Mini Cooper Coolant Bleed Port Location Where To Bleed The Coolingо Easy 2 min bleeding routine common faults. In this video i’ll show you the quick and easy way to bleed the coolant system in your mini cooper s r56 with the n14 engine.mini antifreeze coolant: https:.
Mini Cooper Coolant Bleed Cooling System Youtube R56 mini cooper s coolant system flush & bleed (how to)in this video i show you how flush and bleed your coolant system using distilled water.tools are list. 286 posts · joined 2007. #7 · dec 18, 2007. there are three bleeds as has been said. open each bleed and add coolant until bubble free coolant emerges. durign this process, turn the ignition on and turn the heater to full heat and full blower and leave it on. close each bleed, remove the system pressure cap and start the engine, lettign it. I'm not too familiar with that engine but you could see if there is a bleed screw on the pipe that runs from the water pump to the thermostat. it will probably run along the front of the engine block. the pipe under the expansion tank popped off whilst in traffic and i lost most of the coolant. i found the bleed screw on the thermostat but am. Bled many over the years simple completely remove bleed screw located on top of t.stat (look at your vacum pump just in front of that) when cold and top up header tank untill coolent present at bleed screw. if you don't not wish to remove bleed screw due to it being a bit of a pain to get to make sure you unscrew it at least 80 90% as this.
Comments are closed.