Jeep Grand Cherokee Wj 1999 To 2004 How To Replace Radi In this video grumpy monkey garage shows you how to change a radiator on a jeep grand cherokee.support us on patreon for exclusive long form and behind the s. Showing the easy way to change your radiator in a 1999 2004 jeep grand cherokee. you do not have to take the bumper headlights and header panel off, just the.
How To Replace The Radiator In A 1999 Jeep Grand Cherokee My Step 2 – drain radiator from coolant. open the radiator's cap located on top of the radiator, and locate the drain plug on the bottom of it by the passenger's side. place a container under the drain plug and remove it by turning counterclockwise. let the coolant drain completely. figure 3. Visit our website for more videos at: youfixnsave get a free to download workshop jeep grand cherokee 99 04 free workshop service manual pdf t. Re installation: 11) carefully reinstall the radiator auxiliary cooler condenser shroud assembly into the jeep. a. make sure to line up the rubber alignment dowels into the lower radiator support. 12) reinstall the upper radiator hose and clamp at both ends. 13) reinstall the reservoir hose to radiator filler neck. With the water pump fully assembled, we still need to get the radiator in. slip the radiator in place. line up the a c condenser with the radiator and reinstall. make sure to clip the transmission cooler lines back in place. reinstall the radiator shroud and hood latch. reinstall the front grille onto the shroud.
How To Remove The Radiator On A Jeep Wj Grand Cherokee Tips Vortex Re installation: 11) carefully reinstall the radiator auxiliary cooler condenser shroud assembly into the jeep. a. make sure to line up the rubber alignment dowels into the lower radiator support. 12) reinstall the upper radiator hose and clamp at both ends. 13) reinstall the reservoir hose to radiator filler neck. With the water pump fully assembled, we still need to get the radiator in. slip the radiator in place. line up the a c condenser with the radiator and reinstall. make sure to clip the transmission cooler lines back in place. reinstall the radiator shroud and hood latch. reinstall the front grille onto the shroud. Removal: drain the system using the drain valve on the lower driver's side corner of the radiator. connect a piece of hose and drain the coolant into a jug or two. while the coolant is draining, remove the front grill. there are four or five snap type mounting tabs on top. release the tabs and lift the grill off. Step 1 – remove grille and drain coolant. for easiest access to the radiator and radiator drain cock, the front grille should be removed. to remove the front grille, the headlight bezels first need to be removed. depending on the year and model, there are two to four phillips screws holding each bezel in place.
Comments are closed.