How To Change The Power Steering Pump Astro Safari Youtube Here is how to change the power steering pump on a gmc safari or chevrolet astro van. changing the power steering pump on your van is easy, but it is also me. Power steering pump was leaking from the high pressure line o ring. for preventive maintenance i decided to change the pump along with the high pressure line.
How To Replace Power Steering Pump On Gmc Safari Or Astro Van Yo Not many video guides exist, a few write ups exist on this site (but many of us are visual learners :ugeek: ) i filmed a thorough guide on replacing the power steering pump. removing the fan clutch nut, the pulley, and replacing the evo solenoid (rare on these vans), all these are explained. done on a 1997 gmc safari rwd. 1 1. reply like. sort by. When you remove the ps pump pulley, you'll find three bolts. remove the three bolts and the pump comes off. you can get a power steering pump puller from autozone as a rental. when you buy your new pump, look at the bolt pattern, then locate the bolts on the old pump. like. Normally, down the suction hose and on to the power steering pump. it won't seep past the piston seal, would not interfere with the operation of the hydroboost nor cause it to leak. the reservoir is under no pressure (except the return line) and is gravity feeding the pump. once all leaks are repaired, the fluid level will barely change. An overview of the p s pump and pulley removal and replacement.
Diy How To Change A Chevy Astro Power Steering Pump And Lines Youtube Normally, down the suction hose and on to the power steering pump. it won't seep past the piston seal, would not interfere with the operation of the hydroboost nor cause it to leak. the reservoir is under no pressure (except the return line) and is gravity feeding the pump. once all leaks are repaired, the fluid level will barely change. An overview of the p s pump and pulley removal and replacement. 10. disconnect and cap pressure and return lines from the pump. have a suitable catch pan under the pump. 11. remove pump attaching bolts, then the pump. 12. reverse procedure to install. note: (use the power steering pump pulley installing tool, it's different from the puller tool). To replace the power steering pump on a chevrolet astro, first remove the serpentine belt and disconnect the hoses and wiring harness. remove the mounting bolts and lift the old pump out. install the new pump and reattach the hoses, wiring harness, and serpentine belt.
Comments are closed.