How To Adjust The Steering Box In A Chevy Astrovan Youtube Thisissolution i hope you find this video most profitable!check out the moichandise!dukemanlymakes.redbubble find me on instagram!@duke manly makessupport. The adjustment screw on the steering box is for adjusting the gear lash between the input and output shafts. when a steering box is new this screw is used for the "fine adjustment" of the meshing of these two shafts. if your steering box has developed a sloppy feel, it is because it has wore out and there is play in the meshing of the two shafts.
Astrosafari тав юааsteeringюаб юааboxюаб Replacement How To Or Not To If Youтащre Thanks for watching making it work! please remember to subscribe, click like and tap the bell to get notifications for new uploads!please share if you know s. Old school simplicity. jack the front end up one side at a time under the lower control arm. grab the tire at 12 and 6 and try to move it in and out. then try 9 and 3 and do the same. you are checking for vertical and horizontal play. take a pry bar, place it under the center of the tire and pull up. The worm bearings are adjusted by loosening the big lock nut, then turning the bearing housing. on the 59 and older trucks, this adjustment is at the bottom of the box, at the front. on the 60 newer trucks, look at the top of the box, where the steering shaft (to the steering wheel) sticks out. usually a hammer and blunt punch will loosen the. Put the passenger side wheel in the air, lock the steering wheel. try turning the passenger side tire left and right to check for play in the drag link, and idler arms. the ball joints need to be unloaded to be checked for slop by rocking the tires in and out. tie rods and drag links can be checked for play by squeezing the joints with a big.
Chev S10 Sas Swap Astro Van Steering Box Explained Youtube The worm bearings are adjusted by loosening the big lock nut, then turning the bearing housing. on the 59 and older trucks, this adjustment is at the bottom of the box, at the front. on the 60 newer trucks, look at the top of the box, where the steering shaft (to the steering wheel) sticks out. usually a hammer and blunt punch will loosen the. Put the passenger side wheel in the air, lock the steering wheel. try turning the passenger side tire left and right to check for play in the drag link, and idler arms. the ball joints need to be unloaded to be checked for slop by rocking the tires in and out. tie rods and drag links can be checked for play by squeezing the joints with a big. Blackblaze94 said: astro box is off center to clear the frame, your gonna have to adjust center best you can (1 and 3 4 turn each way) if i remember. i'm pretty sure once you get center the steering wheel will be upside down and then you just gotta flip the link on the fire wall and it'll be near center again. awesome advice, i'll check maybe i. Now slip your 3 16" allen into the adjusting screw and tighten it until snug. important: once snug, back the screw off a quarter of a turn and while holding the adjusting screw with the allen, tighten the nut down with your wrench.
Comments are closed.