Diy Ford Ranger Blower Motor Resistor Replacement Youtube Video tutorial on how to replace the blower motor resistor on a ford ranger. this is a fairly common issue amongst rangers, explorers, and most likely the ma. Whats up everybody!this is a diy how to on replacing the blower motor resistor on a 1995 2011 ford ranger.*disclaimer: i am not a master tech mechanic, just.
How To Replace Blower Motor Resistor 1993 1997 Ford Ranger Youtu In this video i'll show how to replace the blower motor and blower resistor on an 04 ford ranger 3.0l. the process is rather simple and getting the motor an. Remove two more screws (10 mm) holding the tanks in. at this point, there is only one more nut holding the tanks in place (yellow circle). to remove this, you need to remove the air box. start by removing the cover over the throttle body. remove the three screws (7 mm) holding it in. Pull the radiator bottle aside. step 3 :removing the blower motor resistor. 3:04. disconnect the fan motor wiring harness. pull the vent tube collar off of the fan motor. pull the vent tube off of the fan motor. carefully remove the two 8mm bolts from the blower motor resistor, being sure not to drop them. pull out the blower motor resistor. Pry off the clips from the mud flap. remove the three 5.5mm screws from the liner. remove the four 8mm bolts from the liner. remove the plastic clip on the backside of the fender. remove the liner from the fender. remove the vacuum lines on the vacuum reservoir. step 3 :removing the blower motor resistor. 4:10.
Comments are closed.