Xrf Chevy Astro Inner Outer Tie Rod Idler Arm Drag Link Steering Kit Idler arms to frame is: 77 ft lbs. sorry about that. idler arm to relay rod is: 35ft lbs. center link (connecting rod to relay rod): 35 ft lbs. steering knuckle to tie rod end nut: 35 ft lbs. hope this helps. This astro van has loose tie rods and an idler arm. performing what is known as a dry park check is how to reveal looseness in these components when working.
Ball Joint Tie Rod End Idler Arm Kit 12 Piece Set Compatible With Step #1 remove the two bolts mounting the idler arm to the subframe believe this is an 18mm or 19mm. step #2 remove cotter pin and castle nut from the idler arm to drag link ball joint. step #3 separate the ball joint and remove idler arm. installation is reverse of removal. tighten subframe bolt to 77 ft lbs. When you crank the bars up for that extra lift. you effectively also increase the angle of the tie rod. every bump makes the tie rod pull down as well as out. this normally results in the pivot wearing out faster. take that mounting leg section and cut the broken end off. then place it between the frame and new idler arm using longer bolts. Duralast idler arm fa1507. $3949. part # fa1507. sku # 80051. limited lifetime warranty. checkif this fits your chevrolet astro. select store for pickup availability. standarddelivery by sep. 05. Kit includes: (2) front inner tie rod (2) front outer tie rod (2) front tie rod adjusting sleeve (2) front idler arm (1) power steering gear box; built under strict quality control standards; tested for impact, wear and fatigue to ensure quality and durability; manufactured in iso9002 certified facility.
Comments are closed.