2003 F150 Blower Fan Removal And Blower Fan Resistor Replacement Youtube This was an f150 2003 blower motor removal and blower motor resistor replacement. the one thing that i can stress is to start with the screw in the back of t. Easily change out the resistor on your ford f150 blower motor if your fan only works in the high speed only; not on low, or the other 2 (two) selector speed.
How To Replace Blower Motor Resistor 97 03 Ford F 150 Youtube Buy now!new blower motor resistor from 1aauto 1aau.to ic 1ahbr000361a auto shows you how to repair, install, fix, change or replace a bad or broke. 2003 f150 blower motor resistor location. new to this forum and i am seeking information as to the location of the blower motor resistor location on my 2003 f150 with temperature control. i've dropped the glovebox and looked underneath the dash on the passenger side and cannot locate the 4 wire connector or the resistor. It's mounted into an air tube location so air cools it on the lower speed settings. look for a connector attached to a socket and panel bolted into the air tube. good luck. i've seen photos and videos from earlier models, and the resistor with 2 bolts, is clearly visible either under the glovebox or behind it. Start by removing the cover over the throttle body. remove the three screws (7 mm) holding it in. loosen the hose clamp on the throttle body using either a screwdriver or a 5 16" socket. disconnect the breather hose (green circle), maf sensor (yellow circle), and the clip that holds the maf wire harness (blue circle).
Comments are closed.