1997 2003 Ford F150 Blower Resistor Replacement 2 8 Mm Bolts Easy Easily change out the resistor on your ford f150 blower motor if your fan only works in the high speed only; not on low, or the other 2 (two) selector speed. Buy now!new blower motor resistor from 1aauto 1aau.to ic 1ahbr000361a auto shows you how to repair, install, fix, change or replace a bad or broke.
1997 2003 Ford F150 Blower Resistor Replacement 2 8 Mm Bolts Easy This is a how to on replacing you blower motor resistor on a 1996 to 2003 ford f150. the blower had stopped working at the slow and medium speeds. this solve. Good luck. i've seen photos and videos from earlier models, and the resistor with 2 bolts, is clearly visible either under the glovebox or behind it. the 2003 must be different because i cannot spot the 4 wire harness, only the 2 wire harness to the motor. i'm assuming it is behind the dashboard glovebox plastic backing. Step 1 :removing the blower motor resistor. 0:25. remove the screws from the panel. pull out the panel. disconnect the motor resistor wiring harness. remove the two 8mm bolts from the blower motor resistor. step 2 :installing the blower motor resistor. 1:27. insert the blower motor into place. 2003 f150 blower motor resistor location. new to this forum and i am seeking information as to the location of the blower motor resistor location on my 2003 f150 with temperature control. i've dropped the glovebox and looked underneath the dash on the passenger side and cannot locate the 4 wire connector or the resistor.
Comments are closed.