1 Mistake Filling Car Coolant Fluid Youtube Filling your car's coolant reservoir to the full line with fluid does not fill your radiator! check out our channel to save more money on your car repairs.ht. Coolant flush. how to flush a coolant system in your car diy with scotty kilmer. how to fill coolant in car. keep your radiator, heater core, and engine clea.
1 Mistake Filling Car Coolant Fluid Youtube In this video i show how to bleed and fill a cooling system using a cooling system vacuum filler. the particular vacuum filler i am using in the video is a. Whenever you start your car, the engine will gradually heat up, and as it does, the antifreeze will expand in volume. each type of tank provides ample storage space for that expanding coolant to be retained while the engine is running. when the engine is shut off and cools, the coolant will contract and be drawn back into the radiator. If your engine is smoking, that’s a sign of a problem. try and track down the smoke, but if it’s white, then it’s coolant. if you don’t have a visible leak underneath your engine, then you should take a look at your radiator cap or anywhere along the top or sides of your engine. if you find any antifreeze, then you’ve located your. Step 1: locate the overflow tank. before adding any fluid to the radiator, look at the side of the radiator and locate the overflow tank. this small reservoir on the side of the radiator collects any fluid that spills out when the radiator overflows. tip: most overflow tanks have a way to move the coolant they contain back into the cooling.
How To Check Flush Fill Your Vehicle S Coolant Youtube If your engine is smoking, that’s a sign of a problem. try and track down the smoke, but if it’s white, then it’s coolant. if you don’t have a visible leak underneath your engine, then you should take a look at your radiator cap or anywhere along the top or sides of your engine. if you find any antifreeze, then you’ve located your. Step 1: locate the overflow tank. before adding any fluid to the radiator, look at the side of the radiator and locate the overflow tank. this small reservoir on the side of the radiator collects any fluid that spills out when the radiator overflows. tip: most overflow tanks have a way to move the coolant they contain back into the cooling. 3. check the radiator fluid level by looking at the “fill” line. coolant systems don’t normally have a lot of extra room at the top, so the fluid levels should be near the top. if the fluid is more than a few inches from the cap, it’s probably low. look for the “full” or “fill” line etched into the radiator metal. Insert the air tool into the radiator neck or overflow bottle. connect the exhaust hose and compressed air line. route the open end of the tool’s exhaust hose into an empty gallon jug or pail. open the valve and let the vacuum rise until the needle reaches the edge of the red zone on the gauge. step 10.
Comments are closed.